3D printed brackets designed to mount your BMW Panniers and Top Case to the wall keeping them out of harms way until your next adventure!
Supplied as a set for panniers, a single mount for top box or as a full kit for all 3 boxes
Available for the following models:
The plastic alternator belt cover on the front of the R1200 engines have a moulded BMW roundel in the center. There are two holes for mounting a badge, but BMW never made the badge to fit it!
I take an existing badge and modify the mount with a 3d printed part. All you need to do is clean the recess of dirt and grease, peel the film off the 3M sticky pad and push it into the recess. The two pins will align with the cover ensuring your badge is lined up correctly.
Fits all R1200 models from '04-'12 (except R1200R) R Nine T models '15 onward.
Designed and assembled by myself, this BMW badge is mounted in the central hole of the final drive unit. The badge is mounted on bearings with a weight keeping the badge level at all times. Even at 70mph!
Will fit R1200 models 2004 - 2021. Oil cooled and Liquid cooled. R Nine T, K1200/K1300 models. Obviously looks better on models where you can see the rear wheel!
One of the most common faults on modern BMW Motorcycles are switch failures. Up until now the only solution has been to replace the entire unit which can be very expensive and unnecessary considering that it is usually only one or two buttons that fail.
To resolve this issue I use circuit testing tools to find the damaged circuit and in most cases I will run a complete physical wire from the soldered joint at the plug connector right to the button avoiding future issues with the circuit. This is a delicate procedure which can be very time consuming due to the fragile nature of the components.
